![]() ![]() Traditionally, the only way to meet this requirement was to pull the meter out of service and return it to a factory calibration center or a third-party calibration laboratory to have it checked. Whether adding flow sensing to improve a process or replacing poorly performing or high-maintenance flow meters, the ST75 remote mountable flow meter provides an accurate, fast response and low-maintenance solution to small line size gas and air flow applications in hard to reach or hazardous locations.To comply with internal procedures and ensure process integrity and quality, and/or comply with regulations and government mandates, fow meter users are often required to periodically validate and verify the meter’s calibration and operational integrity. II Group A, B, C ATEX/IECEX Zone I, II 2 G Ex d IIC T6.T3 II 2 D Ex td A21, IP67 T90°.T300° (pending) FM/CSA/CRN and CE Marked. It is enclosed in a rugged, all-metal, dust and water resistant NEMA Type 4X (IP66) rated package designed for hazardous area installations. The ST75's rugged sensing element features all welded 316 stainless steel construction with Hastelloy-C tips. There are no orifices or inlets to clog or foul, which significantly reduces scheduled maintenance and unplanned shut-downs. Its no-moving parts design ensures superior service life. The ST75's thermal dispersion technology provides direct-flow measurement for higher performance at a lower cost by eliminating the need for temperature sensors, flow computers, or other devices that are required with orifice plates, Venturis, Vortex shedding, and other meters. ![]() ![]() The instrument can be ordered for input power with either 18 to 36 Vdc or 85 to 265 Vac, with or without a built-in LCD digital display. They are user assignable to flow rate and/or temperature and a 0-1kHz pulse output of total flow. The ST75 Flow Meter's standard outputs are fully scaleable 4-20mA and 0-10V. The ST75's remote mount transmitter, which includes a full digital display, can be mounted up to 50 feet (15 meters) away from its thermal mass flow sensor in the process piping and connected via two 0.50-inch FNPT cables. Remote mount flow meters are ideal in equipment crowded plants or hazardous factory areas where explosive, flammable or toxic gases may be present near the transmitter's electronics. For variable process conditions, the ST75 is factory preset to a wide turndown range at 10:1 to 100:1. The ST75 Flow Meter operates over a wide flow range, from 0.01 to 559 SCFM (0.01 to 950 NCMH) depending on line size, which makes it equally well suited for low flow and high flow applications. Its precision flow element has a no-moving parts design that employs platinum RTD sensors embedded in equal mass thermowells with microprocessor electronics calibrated to laboratory standards for a wide range of gases including: natural gas, methane, nitrogen CO2, argon, all inert gases, compressed air and more. The ST75 Flow Meter features accuracy to ☒% of reading with ☐.5% repeatability and includes media temperature compensation to ensure performance in rugged environments. It is ideal for applications in a wide range of industries including chemical, electric power, food/beverage, advanced materials, pharmaceuticals, semiconductor and more. The ST75 provides three unique outputs: the mass flow rate, totalized flow and media temperature. San Marcos, CA - Instrument and plant engineers who need to measure process gas, fuel gas, inert gas or waste gases as well as air in small line sizes will find the advanced ST75 Flow Meter from Fluid Components International (FCI) is now available in a remote mountable configuration for applications in hazardous areas or hard-to-reach locations.Ĭombining high accuracy with a rich feature set, the ST75 Flow Meter is designed for line sizes from 0.25 to 2.0 inches (6 to 51mm). ![]()
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |